Includes: Battery hold-down/ mounts (front & rear)/ battery compartment spacers/ foam pads (fits Maxx® with extended chassis (352mm wheelbase))

Includes: Motor, Velineon® 540XL, 2400Kv 70mm, brushless (assembled with 6.5mm gold-plated bullet connectors) (for Maxx®/Hoss®) (not for use in marine models)

Includes: Shocks, GTR hard-anodized, PTFE-coated aluminum bodies with TiN shafts (fully assembled w/o springs) (4)

Includes: Connector, power tap (with voltage sensor plug)/ wire tie/ 2.6x8 BCS (2)

Includes: Nerf bars, chassis (2)

Includes: Driveshaft assembly, center, aluminum

Includes: Tailgate protector, green/ 3x15mm flat-head screw (4)

Includes: Window nets (2)/ 2.5x8mm CS (8)

Provides and easy and affordable method of protecting you, your Li-Po batteries, and your equipment in case of explosion or fire

The ST Racing Concepts DR10 Aluminum Wheelie Bar Kit is now available for the popular Team Associated DR10 Dragster.

Includes 375 fasteners

Includes: Cross pin (2)/ drive pin (2) (to rebuild front axle shafts)

Includes: Skid plate set, front/ skid plate, rear/ 3x10 BCS (6)/ 3x30 BCS (1) (fits #8629 & 8630 bulkheads)

Includes: Skidplate, center

Includes: Mount, tie bar, front (1)/ rear (1)

Mini-T 2.0 Chassis Protective Tape, Precut (2)

Includes: Bulkhead tie bars, front & rear, aluminum (red-anodized)

Includes: Bulkhead tie bars, front & rear, aluminum (green-anodized)

This VENDETTA Wing Set contains a high and a low downforce rear wing, left and right wing endplates and all the fixings required for their attachment.

Includes: Screw pins, 4x13mm (with threadlock) (4)

Includes: Shock mounts (front & rear)/ wire clip (1)/ chassis wire clips (4)/ 3x32mm CS (4)/ 3x6mm BCS (1)

Includes: Skidplate, rear plastic (gray)/ stainless steel plate

Includes: Chassis

Includes: Mounting plate, electronic speed control (for installation of XL-5/VXL into Bandit® or Rustler®)