- Radio Control
- Hobbies
- Art & Science
- Toys
- Games
- Gundam
- Rockets
- Puzzles
- Trains
- Gift cards
Your cart is currently empty
SUPER-GOLD+™ gap filling medium thickness are our odorless foam safe CAs.
Ultra-Cure™ is a very high performance clear cyanoacrylate that has a viscosity (thickness) in-between that of Insta-Cure Super Thin and Insta-Cure+ Gap Filling Medium.
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps.
Maxi-Cure™ extra thick CA is the best CA for most plastics.
FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams.
FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams.
INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.
INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.
UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute.
QUIK-CURE 5 min. epoxy cures to a slightly flexible consistency.
QUIK-CURE™ 5 min. epoxy cures to a slightly flexible consistency.
MID-CURE™ 15 min. epoxy is used in larger areas where more working time is needed.
MID-CURE™ 15 min. epoxy is used in larger areas where more working time is needed.
SLOW-CURE™ 30 min. epoxy works best for forming reinforcing fillets on joints.
SLOW-CURE™ 30 min. epoxy works best for forming reinforcing fillets on joints. It has the highest strength of BSI epoxies.
FINISH-CURE™ 20 min. epoxy is an excellent, low odor substitute for polyester resins.
FINISH-CURE™ 20 min. epoxy is an excellent, low odor substitute for polyester resins.
Can be used with all thicknesses of CA except IC-Gel. The flexible tip can be cut to the length and/or inside diameter that is needed for a particular application.
For use over the standard #312 top, it allows BSI's thin CAs (Insta-Cure, Insta-Flex and Super-Gold) to be applied a drop at a time.
Two foot length of tubing can be cut off to any length (usually 2").
Replacement top that is on all of BSI's non-Pocket CAs.
A nostalgic 12" wing span biplane with bright SuperHero graphics. The spacing of the distinctive double wing is maintained by sturdy plastic wing holders.
The Cadet was one of the very first teaching designs of stick and tissue model airplanes when originally released in the 1940's.
