Tamiya Extra Thin Cement is a widely popular glue among modelers around the world.

GOO is the all-purpose adhesive that grips almost anything. It never lets go.

Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds.

Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds.

Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds.

Plastic-Cure™ is a gap-filling formulation of CA that works best on plastics.

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps.

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps.

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps.

MAXI-CURE™ is the best choice for plastic model assembly.

IC-2000™ is a rubber-toughened cyanoacrylate that forms superior shock resistant bonds on non-porous surfaces.

IC-2000™ is a rubber-toughened cyanoacrylate that forms superior shock resistant bonds on non-porous surfaces.

SUPER-GOLD™ is non-frosting and take only 2 or 3 seconds longer to bond compared to Insta-Cure and Insta-Cure+.

SUPER-GOLD™ is non-frosting and take only 2 or 3 seconds longer to bond compared to Insta-Cure and Insta-Cure+.

SUPER-GOLD+™ gap filling medium thickness are our odorless foam safe CAs.

SUPER-GOLD+™ gap filling medium thickness are our odorless foam safe CAs.

Ultra-Cure™ is a very high performance clear cyanoacrylate that has a viscosity (thickness) in-between that of Insta-Cure Super Thin and Insta-Cure+ Gap Filling Medium.

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps.

Maxi-Cure™ extra thick CA is the best CA for most plastics.

FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams.

FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams.

INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.

INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.

UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute.