Feel the soothing warmth of crystal-clear tropical waters and find fabulous fish, sleek dolphins and colorful coral in our “Caribbean Smile” puzzle!

Watch out! It’s not so safe in this haven after all — T-Rex is ready to start a brawl with Stegosaurus in our “Dinosaur Oasis” puzzle!

Take your stress out on globby. Squeeze and pull globby and he returns to his original shape.

These disc magnets are 0.500 inch (12.7mm) diameter and 0.250 inch (6.4mm) thick. They are magnetized through the thickness.

Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds.

SLOW-CURE™ 30 min. epoxy works best for forming reinforcing fillets on joints. It has the highest strength of BSI epoxies.

QUIK-CURE™ 5 min. epoxy cures to a slightly flexible consistency.

Plastic-Cure™ is a gap-filling formulation of CA that works best on plastics.

UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute.

MAXI-CURE™ is the best choice for plastic model assembly.

Maxi-Cure™ extra thick CA is the best CA for most plastics.

INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps.

INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.

From "Gundam Build Divers Re: RISE", Jupitive Gundam arrives sporting a beam gatling gun and backpack unit with remote weapons.

SUPER-GOLD+™ gap filling medium thickness are our odorless foam safe CAs.

SUPER-GOLD+™ gap filling medium thickness are our odorless foam safe CAs.

SUPER-GOLD™ is non-frosting and take only 2 or 3 seconds longer to bond compared to Insta-Cure and Insta-Cure+.

SUPER-GOLD™ is non-frosting and take only 2 or 3 seconds longer to bond compared to Insta-Cure and Insta-Cure+.

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps.

Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps.

Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds.

IC-2000™ is a rubber-toughened cyanoacrylate that forms superior shock resistant bonds on non-porous surfaces.

FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams.