Your cart is currently empty
SUPER-GOLD+™ gap filling medium thickness are our odorless foam safe CAs.
Plastic-Cure™ is a gap-filling formulation of CA that works best on plastics.
FOAM-CURE™ is a silicone based adhesive that works very well on EPP and EPO foams.
SUPER-GOLD+™ gap filling medium thickness are our odorless foam safe CAs.
SUPER-GOLD™ is non-frosting and take only 2 or 3 seconds longer to bond compared to Insta-Cure and Insta-Cure+.
SUPER-GOLD™ is non-frosting and take only 2 or 3 seconds longer to bond compared to Insta-Cure and Insta-Cure+.
IC-2000™ is a rubber-toughened cyanoacrylate that forms superior shock resistant bonds on non-porous surfaces.
FINISH-CURE™ 20 min. epoxy is an excellent, low odor substitute for polyester resins.
For use over the standard #312 top, this provides a rigid tip with extended length to get thin and gap filling CA into hard to reach areas.
QUIK-CURE 5 min. epoxy cures to a slightly flexible consistency.
Insta-Cure™ has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds.
MID-CURE™ 15 min. epoxy is used in larger areas where more working time is needed.
SLOW-CURE™ 30 min. epoxy works best for forming reinforcing fillets on joints. It has the highest strength of BSI epoxies.
QUIK-CURE™ 5 min. epoxy cures to a slightly flexible consistency.
UN-CURE™ debonder will soften cured CA. If parts are bonded incorrectly or your fingers are stuck together, a few drops of UN-CURE™ will dissolve the CA in about a minute.
MAXI-CURE™ is the best choice for plastic model assembly.
Maxi-Cure™ extra thick CA is the best CA for most plastics.
SLOW-CURE™ 30 min. epoxy works best for forming reinforcing fillets on joints.
MID-CURE™ 15 min. epoxy is used in larger areas where more working time is needed.
INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps.
INSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization.
Ultra-Cure™ is a very high performance clear cyanoacrylate that has a viscosity (thickness) in-between that of Insta-Cure Super Thin and Insta-Cure+ Gap Filling Medium.
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps.